SRX AWD V8-4.6L VIN A (2004)
1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Adjust the right rear seat to the rear of vehicle.
5. Pull the carpet away from under the right side of rear seat.
6. When the carpet is pulled away from the rear seat the right rear fuse center (1) will be exposed, then remove the fuse center top cover.
IMPORTANT: With the SIR fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal
operation, and does not indicate an SIR system malfunction.
7. Locate and remove the SIR fuse from the right rear fuse center.
8. Remove both connector position assurance (CPA) from the RF/passenger side impact module and seat belt pretensioner yellow connector (1)
which is located under the front of passenger seat.
9. Disconnect the RF side impact module and pretensioner yellow connector (1) from the vehicle harness yellow connector.
ENABLING PROCEDURE
