SRX AWD V8-4.6L VIN A (2004)
Tail Lamp: Service and Repair
Tail Lamp Replacement
TAIL LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Open the liftgate.
2. Remove the body side rear trim panel.
3. For the right side only, remove the rear speaker.
4. For the left side only, remove the fasteners. Tilt the auxiliary blower motor outward to gain access to the nuts that secure the tail lamp.
5. Remove the nuts (1) that secure the tail lamp (2) to the body.
6. Disconnect the tail lamp electrical connector.
7. Remove the tail lamp.
INSTALLATION PROCEDURE
1. Install the tail lamp assembly.
2. Connect the tail lamp electrical connector
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the nuts (1) that secure the tail lamp (2) to the body.
Tighten
Tighten the tail lamp nuts to 6 N.m (53 lb in).