SRX AWD V8-4.6L VIN A (2004)
14. Hold the J 41425-1 tool body with a 3/8 in breaker bar.
15. Tighten the forcing screw of the J 41425-1 tool. When fully seated, the LOK connector collars will bottom out on the center shoulder of the LOK
fitting.
16. Loosen the forcing screw and remove the J 41425-1 tool from the line.
17. Verify that the LOK fittings are correctly installed.
18. Connect the rearward section of the auxiliary rear suction line to the auxiliary evaporator.
19. Install the auxiliary rear suction line nut to the auxiliary evaporator.
Tighten
Tighten the nut to 9 N.m (80 lb in).
20. Install the auxiliary rear suction line to the body retainers.
21. Connect the auxiliary rear liquid line to the auxiliary evaporator.
22. Install the auxiliary rear liquid line nut to the auxiliary evaporator.
Tighten
Tighten the nut to 9 N.m (80 lb in).
23. Install the auxiliary rear liquid line to the body retainers.
24. Install the LH rear wheel and tire assembly.
25. Install the engine exhaust.
26. Lower the vehicle.
27. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
28. Leak test the fittings of the components using J 39400-A.
