SRX AWD V8-4.6L VIN A (2004)
16.
Install the transmission support to frame bolts.
17.
Install the 4 rear cradle bolts.
Tighten
Tighten the rear cradle bolts to 191 Nm (141 lb ft).
18.
Remove the support from the engine.
19.
Install the new clips to the service pigtails and secure to the transmission.
20.
Connect the shift linkage to the transmission.
21.
Install the transmission manual shift shaft nut.
22.
Install the underbody heat shield and the 4 bolts.
23.
With the aid of an assistant, raise the exhaust system into position, aligning the exhaust pipe flanges with the studs located in the rear of the
exhaust manifolds.
24.
Finger tighten the nuts to the exhaust manifolds studs.
25.
Press the tail pipe hangers over the tail pipe hanger rods.
26.
Press the front exhaust hangers over the rear suspension hanger rods.
27.
Tighten the exhaust pipes to exhaust manifold nuts.
Tighten
Tighten the nuts to 30 Nm (22 lb ft).
28.
Install the tunnel brace and the 2 bolts to the floor pan.
Tighten
Tighten the bolts to 25 Nm (18 lb ft).
Parts Information
Parts are currently available from GMSPO.
Warranty Information
