SRX AWD V8-4.6L VIN A (2004)
10.
Disconnect the electrical connector from the electronic throttle control sensor.
11.
Disconnect the electrical connector from the linear position sensor. This connector is located between the brake pedal assembly and the steering
column. Removal of the connector retainer from the bracket allows the connector to be gently pulled down and disconnected.
12.
Carefully lift the retaining tabs on the end of the accelerator pedal cable (1) using 2 thin-bladed tools.
13.
Disconnect the adjustable accelerator pedal cable (1) from the pedal assembly.
14.
Remove the accelerator pedal assembly from the vehicle.
Installation
Important:
Ensure that the adjustable accelerator pedal and adjustable brake pedal are synchronized in the full forward, front of vehicle position.
Important:
During the synchronization procedure, do not exceed 0.5 Nm (4.43 lb in) of torque while adjusting the pedals with the use of the cable, or the
square drive.
1.
Synchronize the pedals to the full forward (front of vehicle) position.
2.
Synchronize the brake pedal to the full forward position. Use the instrument panel switch, the Tech II, or manually move the brake pedal as
follows:
A.
Use an adjustable wrench on the accelerator pedal end of the accelerator pedal cable (1).
B.
Slowly rotate the accelerator cable to move the brake pedal to the full forward, front of vehicle position.
C.
Remove the wrench from the vehicle.
3.
The new accelerator pedal assembly should already be synchronized to the full forward position. If the pedal is not synchronized, proceed as
follows before installation:
Install a square drive tool into the accelerator pedal where the cable attaches.
