SRX AWD V8-4.6L VIN A (2004)
Fuel Pressure: Testing and Inspection
Fuel Pressure Gage Installation and Removal
FUEL PRESSURE GAGE INSTALLATION AND REMOVAL
TOOLS REQUIRED
J34730-1A Fuel Pressure Gage
INSTALLATION PROCEDURE
CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Service Precautions.
NOTE: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
-
The fuel pipe connections
-
The hose connections
-
The areas surrounding the connections
1. Remove the fuel injector sight shield.
CAUTION: Refer to Fuel Gage Leak Caution in Service Precautions.
2. Install the J 34730-1A to the fuel pressure service connection, located on the fuel rail.
3. Turn ON the ignition, with the engine OFF.
CAUTION: Refer to Fuel Storage Caution in Service Precautions.
4. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
5. Open the bleed valve on the fuel pressure gage in order to bleed the air from the fuel pressure gage.
6. Command the fuel pump ON with a scan tool.
7. Close the bleed valve on the fuel pressure gage.
8. Command the fuel pump ON with a scan tool.
9. Inspect for fuel leaks.
REMOVAL PROCEDURE
