SRX AWD V8-4.6L VIN A (2004)
1. Thoroughly clean the mating surfaces of the knock sensor and the engine block. The entire contact surface of the knock sensor must lie directly on
the engine block.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: DO NOT use washers, spring washers, or toothed washers when installing the knock sensor.
Tighten the bolt to the proper torque.
2. Install the knock sensor (1) and the bolt to the engine block.
Tighten
Tighten the knock sensor bolt to 20 N.m (15 lb ft).
IMPORTANT: The knock sensor wiring harness is held in place with several retaining clips.
3. Ensure that the wiring harness is installed correctly.
4. Connect the electrical connector (3) to the knock sensor (4).
5. Install the intake manifold.