SRX AWD V8-4.6L VIN A (2004)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - Cold Hard/No Start Condition
Bulletin No.: 05-06-04-015A
Date: March 24, 2006
TECHNICAL
Subject:
Engine Hard to Start and/or No Start Cold (Reprogram ECM)
Models:
2004-2005 Cadillac SRX
2005 Cadillac STS
with 4.6L V8 Engine (VIN A - RPO LH2)
Supercede:
This bulletin is being updated to include additional diagnostic information. Please discard Corporate Bulletin Number 05-06-04-015 (Section 06 -
Engine).
Condition
Some customers may comment that the engine is hard to start cold, no start cold, runs rough cold, won't continue to run cold, or is hard to restart cold.
Cause
Engineering has identified a concern with the ECM software.
Ensure Following Conditions are Met Before Programming ECM
^
There are no charging system concerns.
^
Battery voltage is between 12-16 volts. If a battery charger is needed, less than 5 amp charge when programming ECM. It is very likely that a DTC
P2119 will set after a reflash if the system voltage is low.
^
Turn off or disable any system that may put a load on the vehicle battery.
^
Ambient and coolant temperature during reflash should be above 5°C (41°F). If the temperature is below 5°C (41°F), the vehicle will go into
"reduced power" on start-up due to insufficient throttle learn.
^
If the VIN is not properly entered into the ECM, a DTC P0315 will continue to set until the ECM VIN matches the BCM.
^
Anytime an ECM, crank sensor, crankshaft and/or engine is replaced, a CKP System Variation Learn Procedure must be performed.
^
After performing a CKP System Variation Learn Procedure, the ECM must do a proper power down to store the CKP System Variation Learn
Procedure values or a DTC P0315 will continue to set until values are stored.
^
The ignition switch must be in the proper position. The Tech 2(R) prompts you to turn ON the ignition, with the engine OFF. DO NOT change the
position of the ignition switch during the programming procedure, unless instructed to do so.
Correction
Important:
If routine diagnosis does not identify the cause of the above condition, then program the ECM. Refer to and print a copy of the Service Programming
System (SPS) using the appropriate Service Information (SI) procedures to assist in programming the ECM.
Reprogram the ECM with the latest calibrations. Refer to Service Programming System (SPS) using the appropriate Service Information (SI) procedures.
The new calibrations were released beginning with TIS satellite data update version 2 which was broadcast to dealers on 02/05/05. For the dealers that
use CDs, the were mailed on 02/11/05. As always, make sure your TECH 2(R) is updated with the latest software version.
Warranty Information
