SRX AWD V8-4.6L VIN A (2004)
10. Using a suitable pin punch (1). Install the manual shift shaft position switch retaining pin (2).
11. Connect the electrical connector to the manual shift shaft position switch.
12. Install a 0.8 mm spacer (2) between the manual shaft detent lever (1) and the manual shaft detent spring (3).
13. Notice:
^
Tighten the detent spring bolts.
^
Tighten the bolts to 11 Nm (97 inch lbs.).
14. Remove the spacer (2).
15. Install the transmission fluid pan and filter.
16. If previously removed, install a new shaft seal using J 44767.
17. Position the seal onto the J 44767 before installing the seal into the transmission case.
18. Carefully slide the seal and tool over the manual shift shaft and Insert the seal into the transmission until fully seated
19. If previously removed, install a new cup plug. Lubricate the cup plug with transmission fluid before installation.
20. Insert the cup plug into the transmission until flush with the transmission case.