SRX AWD V8-4.6L VIN A (2004)
11. Clean the surface of the EBCM/BPMV assembly.
12. Important: The EBCM cannot be repaired. If faulty, the unit must be replaced.
Separate the EBCM (1) from the BPMV (2).
Installation Procedure
1. Clean the seal surface of the BPMV (2).
2. Install the EBCM (1) to the BPMV (2).
3. Make sure that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
4. Notice: Refer to Fastener Notice in Service Precautions.
Important: Use New EBCM/BPMV screws after separating the EBCM from the BPMV.
Install the 4 NEW EBCM to BPMV screws.
Tighten the (4) NEW EBCM to BPMV screws in sequence (1/4) to 5 Nm (44 inch lbs.).