SRX AWD V8-4.6L VIN A (2004)
20.
Use caution while reaching in and turn the ignition switch to the ON position.
21.
Update the SDM Primary Key number in the DIM using the following steps:
A.
Connect the Tech 2 and build the vehicle.
B.
Select Body Control Module.
C.
Select Dash Integration Module.
D.
Select Special Functions.
E.
Select Set Up SDM Serial Number in DIM.
F.
Clear any codes.
G.
Turn off and disconnect the Tech 2.
22.
Turn the ignition switch to the OFF position and then to the ON position. The AIR BAG indicator will flash and then turn off.
23.
Perform the SIR diagnostic system check if the AIR BAG warning indicator does not operate as described.
SRX
Removal
1.
Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2.
Turn the ignition switch to the OFF position.
3.
Remove the key from the ignition switch.
4.
Adjust the right rear seat to the rear of the vehicle.
5.
Remove the right rear sill plate.
6.
Pull the carpet away from under the right side of the rear seat.
7.
When the carpet is pulled away from the rear seat, the right rear fuse center (1) will be exposed, then remove the fuse center top cover.
Important:
With the SIR fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation
and does not indicate an SIR system malfunction.
