SRX AWD V8-4.6L VIN A (2004)
9.
Connect the right and left console harness connectors (1).
10.
Install the screws (1) securing the console to the floor.
Tighten
Tighten the fasteners to 25 Nm (18 lb-ft).
11.
Connect the traction control electrical connector.
12.
Install the trim plate to the console with the front tabs.
13.
Push down on the rear of the trim plate to lock it into the console.
14.
Install the driver and the passenger seats to the original position.
15.
Install the SIR fuse into the right rear fuse center (1).
16.
Install the right rear fuse center cover.
17.
Position the carpet back under the right rear seat.
18.
Install the right rear sill plate.
19.
Use caution while reaching in and turn the ignition switch to the ON position. The AIR BAG indicator will flash and then turn OFF.
20.
Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described.
