SRX AWD V8-4.6L VIN A (2004)
Seat Belt Retractor: Service and Repair
No.1 Rear
SEAT BELT RETRACTOR REPLACEMENT - NO.1 REAR
REMOVAL PROCEDURE
1. Remove the side door opening frame garnish molding.
2. Remove the body side rear trim panel.
3. Remove the rear seat belt upper guide shoulder bolt (1).
4. Remove the bolt that retains the seat belt retractor assembly (2) to the body.
5. Remove the rear seat belt lower anchor bolt.
6. Remove the seat belt retractor assembly from the vehicle.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the seat belt retractor assembly (2) to the vehicle.
Tighten
Tighten the rear seat belt retractor bolts to 70 N.m (52 lb ft).
2. Install the body side rear trim panel.
3. Insert the seat belt through the side door opening garnish trim.
4. Install the rear seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.