SRX AWD V8-4.6L VIN A (2004)
8. Remove the push-in fastener securing the power seat switch (2) to the seat cushion frame (3).
9. Slide the power seat switch (2) from the seat cushion frame (3).
NOTE: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
10. Disconnect the electrical connector (1) from the power seat switch.
INSTALLATION PROCEDURE
1. Install the wiring harness in the position in which it was removed.
2. Connect the electrical connector to the power seat switch.
3. Slide the power seat switch upward into the seat cushion frame.
4. Install the push-in fastener in order to secure the power seat switch to the seat cushion frame.
5. Install the seat cushion cover over the switch.
6. Position the power seat switch bezel over the switches.
7. Engage the power seat switch bezel fasteners in order to secure the bezel to the seat cushion frame.
8. Install the power seat switch knobs.
9. Install the seat cushion.
10. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 driver's seat and SIR Disabling and Enabling Zone 9 and passenger seat.
