SRX AWD V8-4.6L VIN A (2004)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor Replacement - Bank 2 (Left) Intake
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT - BANK 2 (LEFT) INTAKE
REMOVAL PROCEDURE
1. Remove the fuel injector sight shield.
IMPORTANT: When disconnecting more than one sensor, mark the connectors to ensure correct re-installation. The electrical connectors are
physically interchangeable, however, they must be installed to the correct sensor.
2. Disconnect the electrical connector from the left bank intake camshaft position sensor (1).
3. Remove the camshaft sensor retaining bolt.
4. Remove the left bank intake camshaft sensor (3).
INSTALLATION PROCEDURE
IMPORTANT: Inspect the camshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.