SRX AWD V8-4.6L VIN A (2004)
17.
Install the retaining bracket that was installed on the new power steering cooler hose (Step 12) to the A/C condenser assembly.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
18.
Install the front air deflector.
19.
Lower the vehicle.
20.
Tighten the upper power steering cooler retaining screw and washer assembly (2), P/N 11516931.
Tighten
Tighten the screw to 27 N.m (20 lb ft).
21.
Fill and bleed the power steering system. Refer to Bleeding the Power Steering System in the Power Steering System sub-section of the Service
Manual.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table shown.
Disclaimer
