SRX AWD V8-4.6L VIN A (2004)
1. Remove the key from the ignition switch.
2. Connect the RF side impact module and pretensioner yellow connector (1) to the vehicle harness yellow connector.
3. Install both CPA locks to the RF side impact module and pretensioner yellow connector (1).
4. Install the SIP fuse into the right rear fuse center (1).
5. Install the right rear fuse center cover.
6. Position the carpet back under the right rear seat.
7. Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
8. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check.
