SRX AWD V8-4.6L VIN A (2004)
Steering Mounted Controls Transmitter: Service and Repair
Steering Wheel Control Switch Assembly Replacement
Removal Procedure
1. Caution: Refer to SIR Caution in Service Precautions.
Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Air Bags and Seat Belts.
2. Remove the steering wheel inflatable restraint module.
3. Disconnect the electrical connectors for the steering wheel control switch.
4. Remove the retaining screws from the steering wheel control switch.
5. Remove the retainer and screw from the steering wheel control harness.
6. Carefully pull the control switch assembly away from the steering wheel.
7. Remove the control switch assembly from the steering wheel.
8. Remove the wire harness from the control switch assembly.
Installation Procedure
1. Install the wire harness to the steering wheel control switch assembly.
2. Align the control switch assembly engagement tabs to the steering wheel.Push in on the control switch assembly in order to secure the assembly to
the steering wheel.
3. Notice: Install the control harness retainer and screw.
Tighten the screw to 2.3 Nm (20 inch lbs.).
