SRX AWD V8-4.6L VIN A (2004)
Installation Procedure
1. Install 2 NEW fluid filter seals (1), onto the transmission fluid filter neck. Coat the new seals with a small amount of J 36850 or petroleum jelly
before installation.
2. Install the transmission fluid filter (2) into the case.
3. Important:
Fluid pan gaskets are reusable. Replace the gasket ONLY if the sealing surface is damaged.
Install the fluid pan (2) and the gasket (4) at the same time.
4. Notice:
Install the fluid pan bolts (3).
^
Tighten the bolts to 11 Nm (97 inch lbs.).
5. Fill the transmission to the proper level.
6. Lower the vehicle.
7. Inspect the oil pan gasket for leaks.