SRX AWD V8-4.6L VIN A (2004)
5. Install the center console assembly.
6. Install the shift control trim plate by inserting the front retaining tabs to the console. Then press down on the rear of the trim plate to engage the
rear retaining tabs.
7. Raise and support the vehicle.
8. Connect the shift control linkage rod to the shift control assembly.
9. Install the shift control linkage adjustment nut finger tight.
10. Adjust the shift control linkage.
11. Lower the vehicle.
Shift Control Linkage Replacement
Shift Control Linkage Replacement (AWD)
Removal Procedure
1. Raise and support the vehicle.
2. Remove the nut from the shift control linkage rod.
3. Disconnect the shift control linkage rod from the shift control assembly.
4. Remove the manual shift shaft nut.
5. Remove the shift control linkage from the vehicle.
Installation Procedure
1. Install the shift control linkage to the vehicle.
