SRX AWD V8-4.6L VIN A (2004)
16. Install J 45012 (2) in order to hold the flange with a breaker bar. Tighten the pinion flange nut with a torque wrench and J 29873 (1).
^
Tighten the pinion flange nut to 241 Nm (178 ft. lbs.).
17. Using J 46265 (2) and J 8092 (1), install the stub shaft seal.
18. Install the selected shims (9) on the pinion housing (3).
19. Install the O-ring (11) in the groove on the pinion housing.
20. Important:
Inspect the bearing housing for nicks and burrs. Remove if necessary.
