SRX AWD V8-4.6L VIN A (2004)
13. Important:
The inner race ring groove must be positioned down.
Position the cage and inner race so they are level.
14. Align the cage windows and inner race ball tracks with the outer race ball tracks.
15. Position a cage window and inner race ball track for ball installation.
1. Press down on the cage following one of the outer race ball tracks. The opposing cage window and inner race ball track will be accessible for
ball installation.
2. After installing the first ball, use a brass drift and a hammer to tap gently on the cage, in order to drive the cage and inner race down
completely.
16. Important:
No gap should exist between the ball and the inner race ball track.
Insert a ball through the cage window onto the inner race ball track.Tap the ball lightly with a plastic tipped hammer.
17. Position the cage and inner race so they are level.
18. Important:
The ball installation sequence must be followed as shown.
Repeat steps 17 through 19 in the installation sequence as shown, until all of the balls are installed.
19. Insert approximately 60 percent of the grease from the service kit into the outer joint.
1. Spread 60 percent of the grease onto the ball tracks, the balls, the cage and the inner race.
2. Spread the remainder of the grease into the bottom of the outer race.
20. Remove the outer joint from the bench vise.
