SRX AWD V8-4.6L VIN A (2004)
14. Important:
The seal retaining clamp must not be over-tightened or under-tightened.
Using the J 42572 (1), crimp the small seal retaining clamp.
^
Tighten the small seal clamp until the base of the omega ohm shape has a gap of 1 mm (0.039 inch).
15. Insert the remaining grease from the service kit into the seal.
16. Position the large seal retaining clamp (1) onto the seal (2).
17. Position the seal and large retaining clamp to the joint outer race (3) as shown.
18. Position the joint assembly to the proper vehicle dimension.
19. Measure the distance (1) between the seal edges. 86.85 mm (3.42 inch).
