SRX AWD V8-4.6L VIN A (2004)
5. Remove the O-ring seals (4-5) from the 2-3 shift solenoid (7) ONLY if the O-rings are cut or worn.
Installation Procedure
1. Install new O-ring seals (4-5) to the 2-3 shift solenoid (7), if the O-rings were previously removed.
2. Install the 2-3 shift solenoid (7) into the control valve body.
3. Install the 2-3 shift solenoid retainer into the control valve body.
4. Connect the electrical wiring harness connector (1) to the 2-3 shift solenoid (2).
5. Install the transmission fluid pan.
4-5 Shift Solenoid Replacement
4-5 Shift Solenoid Replacement
Removal Procedure
1. Remove the transmission fluid pan.
2. Disconnect the electrical wiring harness connector (1) from the 4-5 shift solenoid (2).