SRX AWD V8-4.6L VIN A (2004)
Twisting or tilting of the transmission control module electrical connector while connecting may result in bent or misaligned electrical terminal
pins.
Carefully connect the transmission control module electrical connector (1) to the transmission control module.
4. Lock the transmission control module electrical connector securely to the transmission control module by pushing the retainer (2) toward the
electrical connector (1) until fully seated.
5. The transmission control module must be programmed with the proper software/calibrations. See: Testing and Inspection/Programming and
Relearning
Transmission Control Module Programming Procedure
Transmission Control Module Programming Procedure
TCM Programming Procedures
1. The transmission control module (TCM) must be programmed with the proper software/calibrations. Ensure that the following conditions exist in
order to prepare for TCM programming:
^
The battery is fully charged.
^
The ignition switch is in the RUN position.
^
The Techline equipment cable connection at the data link connector (DLC) is secure.
2. Program the TCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user instructions.
3. If the TCM fails to program, proceed as follows:
^
Ensure that the TCM connection is OK.
^
Inspect the Techline equipment for the latest software version.
^
Attempt to program the TCM. If the TCM still cannot be programmed properly, replace the TCM.