SRX RWD V6-3.6L (2007)
11. Slide the large diameter of the wheel drive shaft inboard seal (2), with the larger clamp (3) in place, over the outside of the trilobal tripot bushing
and locate the lip of the seal in the groove.
Important: The seal must not be dimpled, stretched or otherwise deformed.
12. Inspect the seal for proper shape.
If the seal is not shaped correctly, equalize the pressure in the seal by lifting the seal edge slightly and shape the seal properly by hand.
13. Position the joint assembly to the proper vehicle dimension.
14. Measure the distance (a) between the seal edges.
104.7 mm (4.12 in)
Important: Burp the air from the inner joint seal.
15. Align the following items while latching the retaining clamp:
*
The wheel drive shaft inboard seal (1)
*
The tripot housing
*
The large seal retaining clamp (2)
16. Using the J 35566 (3), latch the large seal retaining clamp.
