SRX RWD V8-4.6L VIN A (2006)
Front Door Interior Handle: Service and Repair
Door Handle Replacement - Front Inside
Removal Procedure
1. Remove the front door trim panel.
2. Remove the fastener (1) attaching the inside door handle (2) to the door trim panel.
3. Remove the door handle from the door trim panel by sliding the handle towards the front of the vehicle.
4. Remove the door handle from the door handle linkage.
Installation Procedure
1. Insert the inside door handle rod (1) into the hole in the door handle assembly (2).
2. Rotate the assembly up towards the front of the vehicle.
3. Slide the assembly (2) towards the rear of the vehicle to engage the three tabs.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the door handle fastener.
Tighten the fastener to 2 N.m (18 lb in).
5. Install the door trim panel.