SRX RWD V8-4.6L VIN A (2006)
1. Replace any broken or missing retainers.
Important: The plastic retainers around the window opening should remain in the liftgate.
2. Connect the rear courtesy lamp electrical connector.
3. Align the two outboard locators on the trim panel with the holes in the liftgate.
4. Apply pressure to attach the clips in the lower portion of the trim panel to the liftgate.
5. Align the outboard clips around the window opening with the slots in the trim panel. Press the panel into position.
6. Install the liftgate rod cover and liftgate rod.
Notice: Refer to Fastener Notice () in Service Precautions.
7. Install the liftgate screw (1).
Tighten the screw to 2 N.m (18 lb in).
