SRX RWD V8-4.6L VIN A (2006)
3. Install both CPAs (1,6) to the left and right front end sensor connectors (2,5).
4. Close front hood.
5. Install the SIR fuse into the right rear fuse center (1).
6. Install the right rear fuse center cover.
7. Position the carpet back under the right rear seat.
8. Use caution while reaching in and turn the ignition switch to the ON position. The AIR BAG indicator will flash then turn OFF.
9. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Testing and Inspection/Initial Inspection and Diagnostic Overview
SIR Disabling and Enabling Zone 2
SIR DISABLING AND ENABLING ZONE 2
DISABLING PROCEDURE
1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
4. Adjust the right rear seat to the rear of vehicle.
5. Pull the carpet away from under the right side of rear seat.
6. When the carpet is pulled away from the rear seat the right rear fuse center (1) will be exposed, then remove the fuse center top cover.
7. Locate and remove the SIR fuse from the right rear fuse center.
IMPORTANT: With the SIR fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal
operation, and does not indicate an SIR system malfunction.
8. When disabling the roof rail module, go to step 9. If the side impact sensor (SIS) needs disabling, go to step 12.
