SRX RWD V8-4.6L VIN A (2006)
1. Position the sunshade cable (3) to the drive tube (2).
2. Push the sunshade cable through the tube into the motor/actuator compartment.
3. With the barrel end of the sunroof/sunshade cable, guide the cable into the rear track channel.
4. Inspect the position of the barrel on the opposite track to ensure the cables are in the same position.
5. Secure the rear track extension (2) and drive tubes (4) to the rear track (3).
6. Position the rear track to the sunroof frame.
7. Ensure that the track aligns with the marks made during the Removal Procedure.
8. Install the rear track screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 5 N.m (44 lb in).
9. Inspect the cross-vehicle measurements on the rear tracks.
10. Install the rear sunshade assembly.
