SRX RWD V8-4.6L VIN A (2006)
5. Secure the rear track extension (2) and drive tubes (4) to the rear track (3).
6. Position the rear track to the sunroof frame.
7. Ensure that the track aligns with the marks made during the Removal Procedure.
8. Install the rear track screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 5 N.m (44 lb in).
9. Inspect the cross-vehicle measurements on the rear tracks.
10. Install the rear sunshade assembly.
11. Install the rear sunroof/sunshade motor/actuator (6)
12. Install the rear vent window and center window panel.
13. Install the headliner.
14. Perform the rear vent window sunshade initialization process. Refer to Sunroof Rear Window Initialization Process.
Sunroof Vent Window / Sunshade and Drive Tube Retainer Replacement
SUNROOF VENT WINDOW / SUNSHADE AND DRIVE TUBE RETAINER REPLACEMENT
REMOVAL PROCEDURE
1. Vent the rear window.
2. Open the rear sunshade.
3. Remove the headliner.
4. Remove the center and rear vent windows.
5. Remove the rear sunshade.
6. Loosen all of the rear track assembly screws.
