SRX RWD V8-4.6L VIN A (2006)
3. Pull the cable until the drive guide link (3) reaches the front edge of the track.
4. Position the track to the bottom of the sunroof frame.
5. Position the bullet end of the window cable (5) into the drive tube (1).
6. Push the cable until the track reaches the drive tubes.
7. Install the drive tube retainer (3).
8. Position the track to the bottom of the sunroof frame.
9. Loosely install the track screws
10. Measure the tracks side-to-side to ensure that both tracks are parallel.
11. Secure the track to drive tube retainers.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 5 N.m (44 lb in).