SRX RWD V8-4.6L VIN A (2006)
9. Measure the tracks side-to-side to ensure that both tracks are parallel.
10. Secure the track to drive tube retainers.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 5 N.m (44 lb in).
11. Install the rear sunshade assembly.
12. Install the rear sunroof vent window.
13. Install the center window panel (2).
14. Perform the sunroof rear vent window/sunshade initialization procedure. Refer to Sunroof Rear Window Initialization Process.
Sunroof Window Front Track Assembly Replacement
SUNROOF WINDOW FRONT TRACK ASSEMBLY REPLACEMENT
REMOVAL PROCEDURE
1. Remove the headliner.
2. Remove the center window panel.
3. Remove the front window motor (4) from the motor/actuator compartment.
4. Remove the front sunshade motor/actuator (2).
