SRX RWD V8-4.6L VIN A (2006)
1. Insert the seat cushion locators, at the rear of the seat cushion frame, into the rectangular openings in the seat adjuster assembly.
2. Secure the wiring harness to the seat cushion frame in the same position in which it was removed.
3. Install the power seat switches.
4. Lower the front of the seat cushion down into position onto the seat adjuster assembly.
5. Install the seat cushion nuts (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nuts (1) to 10 N.m (88 lb in).
6. Enable the SIR. Refer to SIR Disabling and Enabling Zone 7 driver's seat and SIR Disabling and Enabling Zone 9 and passenger seat.
Seat Cushion Replacement - Rear No.1 - Left
SEAT CUSHION REPLACEMENT - REAR NO.1 - LEFT
REMOVAL PROCEDURE
1. Remove the seat from the vehicle.
2. Remove the seat cushion mounting nuts (1) from the seat bottom.