SRX RWD V8-4.6L VIN A (2006)
2. Install the brake caliper bleeder valve cap.
3. Lubricate the new piston seal (3) with Delco Supreme II, GM P/N 12377967 (Canadian P/N 992667) or equivalent DOT-3 brake fluid from a
clean, sealed brake fluid container.
4. Install the new lubricated piston seal (3) into the caliper bore seal groove.
5. Make sure the seal is not twisted.
6. Lubricate the brake caliper bore and the piston (1) with brake fluid.
7. Install the caliper piston (1) into the caliper bore.
8. Install the new piston dust boot seal (2) over the piston.
9. Assemble the J 8092 and the J 46275.
1. Using J 8092 and J 46275 fully seat the dust boot seal (2) into the caliper.
2. Make sure the caliper piston dust boot (2) is properly seated into the groove in the brake caliper bore.
10. Install the caliper to the vehicle. Refer to Brake Caliper Replacement - Rear.
Brake Caliper Bracket Replacement - Front
Brake Caliper Bracket Replacement - Front
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
Caution: Do not move the vehicle until a firm brake pedal is obtained. Failure to obtain a firm pedal before moving vehicle may result in
personal injury.
1. Remove the brake caliper from the brake caliper bracket. Refer to Brake Caliper Replacement - Front.
2. Notice: Support the brake caliper with heavy mechanic's wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which
may cause damage to the brake hose and in turn may cause a brake fluid leak.
Support the brake caliper (1) with heavy mechanic's wire, or equivalent; do NOT disconnect the hydraulic brake flexible hose from the caliper.
