SRX RWD V8-4.6L VIN A (2006)
Brake Hose/Line: Service and Repair
Brake Hose Replacement - Front
Brake Hose Replacement - Front
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Clean all dirt and foreign material from the brake hose and the brake pipe fittings.
4. Remove the wheel speed sensor wiring harness retainers from the brake hose bracket.
5. Remove the front brake hose bracket to steering knuckle mounting bolts (1),
6. Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and contamination.
Disconnect the brake pipe fitting (1) from the brake hose (3), than cap or plug the brake pipe fitting end.
7. Lift the retaining clip over the end of the brake hose.
8. Using a flat-bladed tool, remove the brake hose retainer (2) from the brake hose (3).
9. Remove the brake hose (1) from the brake hose bracket (2).