SRX RWD V8-4.6L VIN A (2006)
5. Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the
ON position.
Connect the EBCM electrical connector (1) to the EBCM (3).
6. Rotate the EBCM connector tab (2) rearward to the locked position.
7. Install the washer solvent container bracket.
8. Install the wheelhouse liner.
9. Install the air deflector shield.
10. Lower the vehicle.
11. Use the scan tool in order to clear the DTCs.
12. Perform the ABS Diagnostic System Check. Refer to Diagnostic System Check - Vehicle.