SRX RWD V8-4.6L VIN A (2006)
1. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake fluid pressure sensor (2) to the EBCM (1).
^
Tighten the sensor to 17 Nm (13 ft. lbs.).
2. Connect the brake fluid pressure sensor electrical connector (3) to the brake fluid pressure sensor (2).
3. Fill and bleed the hydraulic brake system.
4. Perform the Auto Bleed Procedure.
5. Perform the ABS Diagnostic System Check. Refer to Diagnostic System Check - Vehicle.
