SRX RWD V8-4.6L VIN A (2006)
8. Remove the water outlet housing from the vehicle.
9. Discard the water outlet housing gaskets.
10. Clean and inspect the water outlet housing. Refer to Water Outlet Housing Cleaning and Inspection.
11. Remove the following components from the water outlet housing if replacement is necessary:
^
The intake manifold inlet duct and clamp
^
The surge tank inlet hose fitting
^
The heater inlet hose fitting
^
The evaporative emission (EVAP) canister purge solenoid valve-Refer to Evaporative Emission (EVAP) Canister Purge Solenoid Valve
Replacement.
Installation Procedure
1. Install the following components to the water outlet housing if previously removed:
^
The intake manifold inlet duct and clamp
Tighten the manifold inlet duct clamp to 6 Nm (53 inch lbs.).
^
The surge tank inlet hose fitting
Tighten the surge tank inlet hose fitting to 18 Nm (13 ft. lbs.).
^
The heater inlet hose fitting
Tighten the heater inlet hose fitting to 20 Nm (15 ft. lbs.).
^
The (EVAP) canister purge solenoid valve
Tighten the purge solenoid valve bolt to 12 Nm (106 inch lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install NEW water outlet housing gaskets.
3. Bolt (2) is approximately 10 mm longer than the other three bolts (1).
Important: The water outlet housing uses two different size bolts.
4. Install the water outlet housing to the vehicle.
5. Install the water outlet housing bolts.
Tighten the water outlet housing bolts to 25 Nm (18 ft. lbs.).
