SRX RWD V8-4.6L VIN A (2006)
Engine Mount: Service and Repair
Engine Support Fixture
Engine Support Fixture
Tools Required
^
J28467-15 Engine Support Adapter
^
J28467-86 Engine Lift Bracket
^
J28467-87 Engine Lift Bracket
^
J28467-B Universal Engine Support Fixture
Installation Procedure
1. Instructions for the right rear J28467-87 are included at the end of this procedure.
Important: The following procedure is for supporting the engine in vehicle. The J28467-15 is for supporting the engine in vehicle only. It is not
intended to be used for lifting the engine once the engine is removed. The J28467-86 that bolts to the left front cylinder head is used for engine
support in vehicle and engine lifting once the engine is removed. The J28467-87 is only used to lift the engine once the engine is removed from the
vehicle. The J28467-87 can not be used for engine support in vehicle due to limited access to the rear of the right cylinder head in the area where
the bracket mounts.
2. Remove the fuel injector sight shield.
3. Remove the wiring harness push pin from the left front cylinder head bolt hole.
4. Install the J28467-86 to the left cylinder head.
5. Remove the front bolt securing the wiring harness bracket to the right cylinder head.
