SRX RWD V8-4.6L VIN A (2006)
20. The J28467-87 is used to lift the engine once the engine is removed from the vehicle.
21. Remove the ground strap from the right rear cylinder head and bolt the J28467-87 in position.
22. The J28467-87 and the J28467-86 can now be used to lift the engine.
Removal Procedure
1. Unscrew the lift hooks (1) and remove them from the lift bracket and the support brackets. Remove the lift hooks from the tube assemblies.
2. Remove the front tube and support assemblies from the main support beam.
3. Remove the main support beam assembly.
4. Remove the J28467-15 from the right cylinder head.
5. Install the front wire harness bracket bolt.
Tighten the wire harness bracket bolt to 45 Nm (33 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
6. Remove the J28467-86 from the left cylinder head.
7. Install the push pin securing the wiring harness to the left cylinder head.
8. Install the fuel injector sight shield.
