SRX RWD V8-4.6L VIN A (2006)
Blower Motor Switch: Service and Repair
Blower Motor Switch Replacement - Auxiliary (Rear)
BLOWER MOTOR SWITCH REPLACEMENT - AUXILIARY (REAR)
REMOVAL PROCEDURE
1. Remove the center dome lamp assembly.
IMPORTANT: Gently pull downward at the front edge of the center dome lamp assembly to disengage the fasteners.
2. Disconnect the auxiliary blower motor switch (1) electrical connector.
3. Remove the auxiliary blower motor switch (1) screws.
4. Remove the auxiliary blower motor switch (1) from the dome lamp housing.
INSTALLATION PROCEDURE
1. Install the auxiliary blower motor switch (1) to the dome lamp housing.
2. Install the auxiliary blower motor switch (1) screws.
Tighten the screws to 1 N.m (9 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the auxiliary blower motor switch (1) electrical connector.
4. Install the center dome lamp assembly.
