SRX RWD V8-4.6L VIN A (2006)
9. Remove the left carpet retainer trim.
10. Remove the connector position assurance (CPA) (3) from the left/driver roof rail module yellow connector (2).
11. Disconnect the left roof rail module connector (2) from the left roof rail module (1).
12. Remove the left center pillar trim panel.
13. Remove the SIS CPA (1) from the left SIS connector (2).
14. Remove the SIS connector (2) from the SIS (3).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. When enabling the SIS, proceed to step 3. If the roof rail module needs enabling, go to step 6.
3. Connect the SIS connector (2) to the SIS (3).
4. Connect the CPA (1) to the SIS connector (2).
5. Install the left center pillar trim panel.