SRX RWD V8-4.6L VIN A (2006)
The DIM will enter a wake-up state if any of the following wake-up inputs are detected:
-
Activity on the serial data line
-
Detection of a battery disconnect and reconnect condition
-
Door ajar switch
-
Headlamps are ON.
-
Hood ajar switch
-
Ignition is turned ON.
-
Key-in-ignition switch
-
Parklamps are ON.
The DIM will enter a sleep state when all of the following conditions exist:
-
Ignition switch is OFF.
-
No activity exists on the class 2 serial data line.
-
No outputs are commanded.
-
No delay timers are actively counting.
-
No wake-up inputs are present.
If all these conditions are met, the DIM will enter a low power or sleep condition. This condition indicates that the DIM, which is the power mode
master (PMM) of the vehicle, has sent an OFF-ASLEEP message to the other systems on the serial data line.
Rear Integration Module (RIM)
The various rear integration module (RIM) inputs and outputs are described in the corresponding functional areas as indicated on the RIM electrical
schematics.
The RIM functions include the following:
-
BTSI solenoid control
-
Class 2 communication requiring RIM interaction
-
Content theft deterrent
-
Fuel door control
-
Fuel level sensor input
-
Heated seat control
-
Intrusion sensor control
-
Key in ignition chime control
-
Performance shift control
-
Position lamp control
-
Park brake relay control
-
Rear defog relay control
-
Rear fog lamp relay control
-
Rear park assist chime control
-
Reverse lamp relay control
-
Reverse switch input w/manual transmission
-
Sunroof speed control
-
Traction mode switch input
-
Transmission shift inhibit
-
Trunk ajar input
-
Trunk entrapment sensor input
-
Trunk release relay control
-
Winter mode switch w/automatic transmission
