SRX RWD V8-4.6L VIN A (2006)
4. Remove the 2 bolts (1) from the inflatable restraint side impact module bracket.
5. Remove the module from the seat.
6. Remove the Connector Position Assurance (CPA) from the module electrical connector.
7. Disconnect the electrical connector (1) from the module.
INSTALLATION PROCEDURE
1. Install a new inflatable restraint side impact module bracket.
2. Install the 2 bracket mounting bolts to the module.
Tighten the bolts to 9 N.m (80 lb in).
CAUTION: Following the deployment of a side impact air bag, replace the inflator module bracket to the air bag. Failure to do so may cause
future personal injury.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector (1) to the inflatable restraint side impact module.
4. Install the connector position assurance (CPA) to the module electrical connector.
5. Install the module to the seat.
6. Install the 2 bolts (1) to the inflatable restraint side impact module.
