SRX RWD V8-4.6L VIN A (2006)
13. Connect the passenger/RF side impact module and seat belt pretensioner yellow connector to the vehicle harness yellow connector (1) located
under the front of passenger seat.
14. Install both CPA locks to the RF side impact module and pretensioner yellow connector (1).
15. Connect the roof rail module yellow connector (3) to the right roof rail module (1).
16. Install the CPA (2) to the right roof rail module connector (3).
17. Install the right carpet retainer trim.
18. Install the SIR fuse into the right rear fuse center (1).
19. Install the right rear fuse center cover.
20. Position the carpet back under the right rear seat.
21. Use caution while reaching in and turn the ignition switch to the ON position.The AIR BAG indicator will flash then turn OFF.
22. Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System
Check - Vehicle. See: Testing and Inspection/Initial Inspection and Diagnostic Overview
SIR Disabling and Enabling Zone 7
SIR DISABLING AND ENABLING ZONE 7
DISABLING PROCEDURE
1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.
