SRX RWD V8-4.6L VIN A (2006)
2. Install the KS (1) and the bolt to the engine block.
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: DO NOT use washers, spring washers, or toothed washers when installing the KS. Tighten the bolt to the proper torque.
Tighten the KS bolt to 20 N.m (15 lb ft).
3. Ensure that the wiring harness is installed correctly.
IMPORTANT: The KS wiring harness is held in place with several retaining clips.
4. Connect the electrical connector (2) to the KS (1).
5. Install the intake manifold.