SRX RWD V8-4.6L VIN A (2006)
1. Install the knuckle and backing plate to the wheel bearing/hub.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the wheel bearing/hub mounting bolts.
Tighten the bolts to 125 Nm (92 ft. lbs.).
3. Install the knuckle to the vehicle.
4. Important: Loosely install all fasteners before tightening.
Install the adjustment link to knuckle mounting bolt.
Tighten the adjustment link to knuckle bolt to 160 Nm (118 ft. lbs.).
5. Install the trailing arm to knuckle mounting bolt and nut.
Tighten the trailing arm to knuckle bolt to 170 Nm (125 ft. lbs.).