SRX RWD V8-4.6L VIN A (2006)
4. If the sensor bracket is not yet level, continue to rotate it allowing the captured stud to lift slightly from the bottom of the keyhole, until the sensor
is level.
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the rear ride height sensor retaining nut.
^
Tighten the nut to 9 Nm (80 inch lbs.).
6. Connect the ride sensor link to the upper control arm ball stud.
7. Connect the ride sensor harness connector.
8. Install the tire and wheel.
9. Lower the vehicle.
