STS V8-4.6L VIN A (2005)
9. Remove the brake hose (1) from the brake hose bracket (2).
10. Remove the brake hose to caliper bolt (4) from the brake caliper (1).
11. Remove the brake hose (2) from the brake caliper.
12. Place a shop towel on a hard surface.
13. Tap the threaded end of the brake hose to caliper bolt (4) on the shop towel to remove the gasket (3) from the bolt (4)
14. Remove and discard the two copper brake hose gaskets (3). These gaskets may be stuck to the brake caliper (1) and/or the brake hose end (2).
15. Install a rubber plug into the brake hose to caliper bolt hole of the brake caliper.
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and/or contamination.
Installation Procedure
1. Install the front brake hose bracket to steering knuckle mounting bolts (1).
Tighten the brake hose to knuckle mounting bolt to 14 Nm (10 ft. lbs.).
